Home Page Home Page

 Profile Profile

 Model B Model B

 Model E Model E

 Model L Model L

 Contact Us Contact Us

MCKENZIE
INTERMEDIATE
FLOOR TYPE
CHIP
SEPARATOR
...for high production, low cost separation of screw machine parts
from scrap chips. In fact, you can actually process one
day's output of a screw machine in minutes.
  • Automatic feed
  • Quiet, dependable, easy-to-use
  • Rugged, vibration-free
  • Clean, efficient separation of parts
  • Handles parts from smallest Swiss type to multiple spindle work

APPLICATION DATA
Size range (diameters): 0.040" to ¾" (1 to 19mm)
Size range (lengths): ¼" to 3½" (6 to 88mm)
Operating rate: ½ cu. ft./min.
Average operating rate: 14cu. ft./hr., with varying parts and sizes


OPERATION...SIMPLE AND EASY

1. Adjust air blast regulator lever to regulate air flow for size and weight of parts

2. Set control gate in feed hoper to permit uniform flow. (Normal setting: 1½ times diameter of parts to be separated.)

3. With machine running, and after cutting oil has been removed, empty production to be separated into automatic feed hopper.

4. Production will feed into vibrator where, by means of contant agitation, material is spread evenly prior to entering controlled air stream.

That's all. Chips are automatically discharged below chip discharge hood, while clean parts drop from parts delivery chute.
SPECIFICATIONS
Blower motor 2 H.P. continuous-rated, ball bearing, totally enclosed
Feeder-vibrator motor ½ H.P. continuous-rated, ball bearing, totally enclosed
Current Three-phase 208-230/460 volts, 60Hz. (Special electrics available on request)
Motor control Magnetic starter, with current-overload protection panel and pushbutton station
Air blower control 40 air regulator settings, for accurate control over complete blower range
Bearings:
   Connecting Rod Self-aligned roller
   Drive Shaft Ball-bearing pillow blocks
   Vibrator Pan Self-aligning grooved and graphited bronze
Dimensions 4'2"L x 2'11"H x 2'6"W (125 x 88 x 76 cm)
Shipping weight 1020 lbs. (463kg)



COMPARISON
MODEL B
3 Cu. Ft./Hr.
< 1/2" Dia.
< 1" Long
MODEL E
30 Cu. Ft./Hr.
1/16" to 3/4" Dia.
1/4" to 3-1/2" Long
MODEL L
60 Cu. Ft./Hr.
1/8 to 2" Dia.
1/4" to 6" Long



McKenzie Engineering Co.
Correspondence:
P.O. Box 5297
Maryville, TN 37802-5297 		Facility:
3001 Lora Drive
Maryville, TN 37803
Phone: (865) 233-2965   Fax: (865) 233-2964
Email: info@McKenzieEngineering.com